Imagen de Portada

Código QR

The use of electrochemical noise in the study of nanometric coatings

Mostrar otras versiones (1)

This chapter presents the study and analysis of the application of nanometric films of SS 304 and nanometric Al/Cr and Cr/Al bilayers deposited on different aluminum and steel alloys by magnetron sputtering and DC sputtering. The materials were characterized by scanning electron microscopy (SEM) and...

Descripción completa

Detalles Bibliográficos
Autores principales:	Gaona Tiburcio, Citlalli, López Cazares, Irene, Cabral Miramontes, José Ángel, Zambrano Robledo, Patricia del Carmen, Uruchurtu Chavarín, J.
Formato:	Sección de libro.
Lenguaje:	inglés
Publicado:	InTech 2014
Materias:	TA Ingeniería General y Civil
Acceso en línea:	http://eprints.uanl.mx/25182/1/25182.pdf

Ejemplares similares

The use of electrochemical noise in the study of nanometric coatings
por: Gaona Tiburcio, Citlalli, et al.
Publicado: (2014)

Electrochemical Impedance Spectroscopy Behavior of Nanometric Al-Cr and Cr-Al Coatings by Magnetron Sputtering
por: Castillo Morquecho, Jorge, et al.
Publicado: (2012)

Use of Electrochemical Noise for the Study of Corrosion by Passivated CUSTOM 450 and AM 350 Stainless Steels
por: Almeraya Calderón, Facundo, et al.
Publicado: (2024)

Electrochemical Noise Analysis of Nickel Based Superalloys in Acid Solutions
por: Gaona Tiburcio, Citlalli, et al.
Publicado: (2013)

Effect of Cathodic Protection on Reinforced Concrete with Fly Ash Using Electrochemical Noise
por: García Contreras, Jorge, et al.
Publicado: (2021)

Corrosion resistance of multilayer coatings deposited by PVD on inconel 718 using electrochemical impedance spectroscopy technique
por: Gaona Tiburcio, Citlalli, et al.
Publicado: (2020)

Frequency Analysis of Transients in Electrochemical Noise of Superalloys Waspaloy and Ultimet
por: Jáquez Muñoz, Jesús Manuel, et al.
Publicado: (2021)

Electrochemical Noise Measurements of Advanced High-Strength Steels in Different Solutions
por: Montoya Rangel, Marvin, et al.
Publicado: (2020)

A Study of the Corrosion Behavior of AHSS Complex-Phase CP 780 Employing an Electrochemical Noise Technique Analyzed by Different Methods
por: Lara Banda, María del Refugio, et al.
Publicado: (2025)

Parameter Studies on High-Velocity Oxy-Fuel Spraying of CoNiCrAlY Coatings Used in the Aeronautical Industry
por: Cabral Miramontes, José Ángel, et al.
Publicado: (2014)

Electrochemical Noise Analysis: An Approach to the Effectivity of Each Method in Different Materials
por: Jáquez Muñoz, Jesús Manuel, et al.
Publicado: (2024)

Electrochemical Noise Analysis of the Corrosion of Titanium Alloys in NaCl and H2SO4 Solutions
por: Jáquez Muñoz, Jesús Manuel, et al.
Publicado: (2021)

Electrochemical Noise Analysis Using Experimental Chaos Theory, Power Spectral Density and Hilbert–Huang Transform in Anodized Aluminum Alloys in Tartaric–Phosphoric–Sulfuric Acid Solutions
por: Martínez Ramos, Cynthia, et al.
Publicado: (2023)

Electrochemical Behavior of Ti6Al4V Alloy Used in Dental Implants Immersed in Streptococcus gordonii and Fusobacterium nucleatum Solutions
por: De la Garza Ramos, Myriam Angélica, et al.
Publicado: (2020)

Alternative to Nitric Acid Passivation of 15-5 and 17-4PH Stainless Steel Using Electrochemical Techniques
por: Lara Banda, María del Refugio, et al.
Publicado: (2020)

Wear resistance of thermal spray WC-Co-VC nanostructured coatings
por: Cabral Miramontes, José Ángel, et al.
Publicado: (2016)

Corrosion of Titanium Alloys Anodized Using Electrochemical Techniques
por: Jáquez Muñoz, Jesús Manuel, et al.
Publicado: (2023)

Frequency–Time Domain Analysis Based on Electrochemical Noise of Dual-Phase (DP) and Ferrite–Bainite (FB) Steels in Chloride Solutions for Automotive Applications
por: Almeraya Calderón, Facundo, et al.
Publicado: (2024)

Corrosion behavior of Zn-TiO2 and Zn-ZnO electrodeposited coatings in 3.5% NaCl solution
por: Cabral Miramontes, José Ángel, et al.
Publicado: (2019)

Comparative study of CO2 photoreduction using different conformations of CuO photocatalyst: Powder, coating on mesh and thin film
por: Avila López, Manuel Alejandro, et al.
Publicado: (2021)

Corrosion Resistance of Hard Coat Anodized AA 6061 in Citric–Sulfuric Solutions
por: Cabral Miramontes, José Ángel, et al.
Publicado: (2020)

Electrochemical Corrosion of Ferritic 409 and 439 Stainless Steels 409 and 439 in NaCl and H2SO4 solutions
por: Gaona Tiburcio, Citlalli, et al.
Publicado: (2016)

Suitable Conditions for the Use of Vanadium Nitride as an Electrode for Electrochemical Capacitor
por: Morel, Alban, et al.
Publicado: (2016)

Electrochemical Characterization of Modified Concretes with Sugar Cane Bagasse Ash
por: Maldonado Bandala, Erick, et al.
Publicado: (2011)

Improvement of Shelf Life and Sensory Quality of Pears Using a Specialized Edible Coating
por: Cruz, Virgilio, et al.
Publicado: (2015)

Electrochemical behaviour of galvanized steel embedded in concrete exposed to sand contaminated with NaCl
por: Baltazar Zamora, Miguel Ángel, et al.
Publicado: (2016)

Effect of heat treatment on the electrochemical behavior of AA2055 and AA2024 alloys for aeronautical applications
por: Rivera Cerezo, Heriberto, et al.
Publicado: (2023)

Selection of Machining Parameters Using a Correlative Study of Cutting Tool Wear in High-Speed Turning of AISI 1045 Steel
por: Hernández González, Luis Wilfredo, et al.
Publicado: (2018)

Electrochemical corrosion behavior of passivated precipitation hardening stainless steels for aerospace applications
por: Villegas Tovar, José M., et al.
Publicado: (2023)

Electrochemical Study of Interaction between Imidazole-Based-Ionic-Liquid and Light Petroleum in Oil/Water Emulsion
por: Villalobos Neri, E.E., et al.
Publicado: (2021)

All spray-pyrolysis coated photovoltaic structure using copper antimony sulfide absorber and zinc oxysulfide window layers
por: Abraham, Paulosutty
Publicado: (2023)

All spray-pyrolysis coated photovoltaic structure using copper antimony sulfide absorber and zinc oxysulfide window layers
por: Abraham, Paulosutty
Publicado: (2023)

Electrochemical Glucose Oxidation Using Glassy Carbon Electrodes Modified with Au-Ag Nanoparticles: Influence of Ag Content
por: García Morales, Nancy Gabriela, et al.
Publicado: (2015)

Green Synthesis of Magnetic Nanoparticles of Iron Oxide Using Aqueous Extracts of Lemon Peel Waste and Its Application in Anti-Corrosive Coatings
por: Elizondo Villarreal, Nora, et al.
Publicado: (2022)

Study about the emotional valence of environmental concepts using affective priming technique
por: Sánchez Miranda, Martha Patricia, et al.
Publicado: (2013)

A Comparative Study of Corrosion AA6061 and AlSi10Mg Alloys Produced by Extruded and Additive Manufacturing
por: Estupiñan López, Francisco H., et al.
Publicado: (2021)

Electrochemical Corrosion of Titanium and Titanium Alloys Anodized in H2SO4 and H3PO4 Solutions
por: Jáquez Muñoz, Jesús Manuel, et al.
Publicado: (2022)

Identifying factors influencing the corrosion rate of steel using nonparametric statistics
por: Nieves Mendoza, Demetrio, et al.
Publicado: (2012)

Mortars modified with geothermal nanosilica waste: effect on the electrochemical properties of embedded steel rods
por: Puente Ornelas, Rodrigo, et al.
Publicado: (2012)

Nanohardness and Residual Stress in TiN Coatings
por: Hernández, Luis Carlos, et al.
Publicado: (2011)